Messages

Hi All,
  I picked up this early 289 hipo carb and I believe matching intake over the winter. The carb and tag read C40F-AL.  The date code is 4D on both carb and intake. I noticed the carb has tube sticking down into right front venturi, which is different than other C40F-AL carbs I have seen. Can anyone tell me what this carb and intake came off of as I believe its too early for a mustang. Any help would be appreciated. Thanks. Ed

I recently purchased 67 GT500 #1966 with original interior and it has the early style brushed aluminum door panel on drivers side, and later style on passenger side.  It was built in April 1967 so more towards end of production. They must have just been running out of old style then.

Thanks all for your response.  Ed

Hi, I'm looking at 67 GT500 and have question about correct rear end case. Did the SPEC case only come with 4 speed cars, or was it also used on Automatic cars as well. Any input would be appreciated. Thanks.

Sold

Set of 4 NOS Ford Shelby Mustang wheel lip moldings.  New in original packaging. Original packaging is there but falling apart from age. Excellent condition with no damage.

Will be at Ford Carlisle this Thursday and Friday June 5 and 6, Spaces N162 -N163.

Price $500 obo

Pic of the back with harness

For Sale- Original 1967 Mustang tach dash cluster with clock. Cluster wiring harness also included(shown in pics).

This was taken out of original 56,000 mile fastback in 1980 and stored inside dry workshop until now. Very clean and no signs of rust, corrosion, etc.

Needles move freely.  I don't have wiring diagram for 67, but I will test if someone wants to buy it and tell me where to hook up the wires.

Can deliver for free to all ford Carlisle on Thursday or Friday (June 5,6)

Price $750 obo

Thanks for the input.  Ill give damper doctor a call.

Ed

Is there a reputable rebuild service out there that can replace the rubber on my original 289 HiPo harmonic balancer?  Getting ready to rebuild my engine and would like to have this replaced before I have rotating assembly balanced.

Any help would be appreciated.

Thanks.

Ed

Thanks Charles!

I am restoring my 65 K code Dearborn built convertible. The silkscreen on the door tag is weathered so now the tag is just bare aluminum.  I would like to know if it should be Black or Gray?

The original color is Tropical Turquoise and the car was built Jan 15th 1965?

Can anyone tell me what the correct color was?

Any help would be much appreciated. Thanks.

Ed

Hi, Im looking for a 4L date coded ( November 1964) standard 289 block for my Dec 1964 built Mustang.  Would prefer original bore so it can be machined fresh for my build.  Im located in Napa, California.

If you have one in this date range please reply to this post or you can call me at 707-227-6604

Thanks.

Paul

Does anyone know if the rear seat frames for 65 to 70 mustangs are the same?  I have a really nice 69 coupe rear seat back and base that I want to reupholster and use in my 65 coupe.

Any info would be appreciated.

Thanks.

Ed

Awesome.  I knew this was the right place to ask this question.

Solved in less than 15 minutes