Messages

additional pics

additional pics

For sale is a C5ZF-E 65 Mustang Autolite 4100 4 barrel carburetor for a 3/4 speed car. Also correct for a Falcon, Fairlane, Comet, Cyclone and Torino.

Carburetor was rebuilt by a previous owner and then ran on his car, I picked up this carb for my 65 only to remember I already had a C5ZF-E carb on the shelf for it. Carb has been painted, does not have it's original finish.
Has the correct CS primary booster (used on cars made after 10/16/1964, prior to 10/16/1964, the CF booster was used) and A secondary booster.

Per Bob Mannels Small Block V8 book, this is correct for a PCV valve car, but will also work with a road draft tube set up.

Carb is missing the choke lever that goes up the side of the carb to the choke flap, and the threads at the base of the choke where the heat tube threads on are a little buggered up (see pics). Everything moves freely.

Asking $375 plus shipping.

More pics

More pics

For sale is a basically new Blue Thunder 289 High Rise Dual Quad intake manifold.

A reproduction of the intake manifold sold through Fords High Performance Catalog. Intake appears to have been mounted, given the witness marks on the intake bolt holes, but otherwise looks new on the milled head surfaces. There is a small nick on the back carb pad, as shown in the pics. All threads are good, there is a small blemish on the thermostat threads, shown in the pics. the thermostat threads in just fine and seals, just wanted to show a pic of the very small area.

Currently sold out new everywhere to the best of my knowledge, asking $600 plus shipping

SOLD

Price adjusted

PM sent

Snubber bracket SOLD

more pictures

For sale is a pair of original 65 HiPo 289 GT350 upper motor mount brackets.

Very little pitting, mainly where the rubber doughnut mounted to the bracket. The tooling marks and makers stamp is still visible.

These were soaked in Evapo Rust for 3 days then coated with Bioshied. these were not media blasted.

Asking $150 plus shipping. 

SOLD

more photos

More photos

For sale is an early original 20" C7ZE-8146-B fan shroud for a 1967 Shelby GT350 HiPo 289 or Mustang w/ A/C

Has the correct early square FoMoCo block letters

It has a repair done in the upper right corner (passenger side), see pictures

No broken mounting tabs

Asking $450 $400 plus shipping

Additional pictures