Backup light switch wiring

[azdriver]

Supposed to have one or two of these clips? If two, where does the second one go?

Thanks, Pat

[Special Ed]

69 has 1 but dont 68 have 2 by shifter

[Bob Gaines]

69 has 1 but dont 68 have 2 by shifter

You are remembering correctly . 68 has two . The first one goes on the front shift control adapter plate holding bolt  as in the picture and the second one goes on the rear shift control bolt.

[Bob Gaines]

69 has a different shift control which explains the different mounting.

[azdriver]

So i need to relocate as this is a 68.

Pat

[Bob Gaines]

So i need to relocate as this is a 68.

Pat

Your car your choice.I would suggest getting all of the 68 assemblyline manuals . The clips are illustrated in the electrical manual.

[1175]

What about 67? Similar to 68?
Jon

[Bob Gaines]

What about 67? Similar to 68?
Jon

I revised reply #2 . 67 and 68 are the same.

[Special Ed]

I had that wire holder clip made back in 2005 because it was very hard to find after everybody installed hurst shifters back in the day and if u dont install that clip your reverse wire can end up getting melted on exhaust pipe when not routed correctly.

[azdriver]

Thanks,

Pat