Source for Koni Rear Shock Absorber Mounting Nuts (4)

[TA Coupe]

If your guys were real men who actually worked on your cars, you would have a Tap and die set that would have a thread pitch. And count tool, that would be part of it. Mine does.
🤣😂😁😄😝

     Roy

[Coralsnake]

Lots of nuts in this thread

[S7MS427]

Did anyone think of just measuring the OD of the thread to see what it is? That would help...

[SHELB66]

This is the gauge I have to help me identify nuts and bolts. I found some Koni hardware on a later used shock while digging through some parts today and this is what the gauge identified it as. 

We have a match, Bob!  Thanks very much.  This size (M10x1.0) is readily available.  Thanks also to everyone else for chiming in.

Craig R.

PS:  KONI just emailed me confirming the size.