News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - oldcanuck

#361
1967 Shelby GT350/500 / Ammeter Wiring ?
January 15, 2020, 03:18:36 PM
I did a search but found nothing on this.... but my question is..... I have read somewhere guys remove, or just don't connect their ammeter wiring harness for fear of an electrical problem.... or fire ?

Is this true, and can someone enlighten me prior to me hooking mine back up on my GT-350  ?

Thanks in advance,
Bob
#362
Congratulations ..... nothing beats finding something you can really be proud of, and enjoy driving like you stole it.... even if you did pay thru the nose !
#363
Guys,

Still looking.....Thanks

Bob


#364
Ask a Registrar / Re: 1966 GT-350H
November 18, 2019, 07:57:01 PM
Tony,

Thank You,

Bob
#365
Ask a Registrar / 1966 GT-350H
November 18, 2019, 08:54:49 AM
How can I get in touch directly with the 1966 Registrar please ?

Thank You,
Bob
#366
1967 Shelby GT350/500 / Re: Nose/Hood fit
November 12, 2019, 09:51:29 PM
I was always under the impression if all the fiberglass and steel gaps were perfect, it had been messed with.
#367
Good used repro 10 spoke or 15x6 steel will be fine...... I would prefer a plain black steel wheel.

My GT350 is a driver, so I dont really need a $400.- original.

Thank You,

Bob
#368
Guys,

Still looking......

Thanks,

Bob
#369
Wanted to Buy / Re: '67/350 15x7 Steel Wheels
October 30, 2019, 08:05:20 PM
I'm looking for one of those as well......
#370
1967 Shelby GT350/500 / Re: Front tire size selection
October 29, 2019, 08:30:56 PM
The reason I asked .......
#371
1967 Shelby GT350/500 / Re: Front tire size selection
October 29, 2019, 06:52:41 PM
Quote from: Tom Honegger on October 10, 2019, 10:26:36 AM
225 60's. Fender lip rolled, lowered springs. No rubbing issues, unless you
turn into a "ramped" driveway at speed.

Tom,

Is that raven black with silver stripes I see ???

Bob


PS.... I screwed up when I put 215/60R15s on the front..... should have gone 215/65R15 to match the 235/60R15s on the back..... rookie mistake.
#372
If I somehow mess it up, can the plastic line be sourced ?
#373
Thanks Bob..... kinda what I thought. Does the plastic line become brittle/fragile with time ?

I'm assuming I need to be very careful with it........
#374
JD,

Thank you for the information.......

Is there a special way to remove/install the sending unit on the extension.... or the tube ?

Thanks again,

Bob
#375
It appears that I have a bit of seepage at one of the ends on my extension.

I was going to remove and either reseal, or replace, until I saw that my oil pressure sender appears not to be connected by an electrical wire, but what looks to be a very small id plastic line. I'm assuming a small vac line.

Please educate me as to what I am looking at, and how best to deal with it ?

Thank you in advance.

Bob