Messages

What are the date and block codes on the HiPo?

When did the 67  steering columns change from the one piece to 2 piece?
When did the 67 fuel line route change from transmission tunnel to frame rail?

That would be great. Thanks.

More questions'

What  kind of adhesive or sealant goes around the side scoops and end caps? How big a bead?

I read somewhere that is was common to swap out the headlight switch with a Cougar headlight switch because it handles the center and headlight load better. Can someone elaborate on this?

Thank you!

Bob,
   I sent you a PM reply. I'm also looking for a correct radiator if you have any leads on that too.

Thank you, that picture helps quite a bit.

Another question.. my taillights didn't have this panel, should it? Did all 67's have this? Where can I source if needed?

Thanks Bob!

Hello,
   I'm about to start putting my GT350 #2087 back together and have a couple questions I'm hoping someone could help me with.

1. The rear body panel that holds the tail light assembly- Is there caulking or something that goes behind the panel to seal it? The car had been repainted blue previously in the 80's and silicone had been used to fill the gaps, it looked pretty sloppy and not correct but I imagine something went in there. I have  attached a picture to clarify what I'm referring to.

2. Is strip caulk used between the gas tank and body of the car?

3. The taillight housing had a gasket plus strip caulk before mounted. I'm going to clean them up but is that correct also? Have have attached a picture of what it looked like after removal

4. What color is the rear wheel well supposed to be? Black, body color, red oxide primer?

5. My leaf spring snubbers that protect against wheel hop are missing the rubber, what can I use to replace them? If I cant find OE replacement what is a good alternative?

6. Can someone please provide a visual reference to how the center head lights were wired? I understand they were spliced in but would like to see a couple pictures if possible.

Thanks!

PM inbound.

I didn't see any numbers on the rods, I'm pretty confident those aren't for T-10 or Top Loader....I'd be curious to know what they're off of though.

Besides the knob, trunnions, grommets and springs for the shift lever what else do you see missing

Can someone verify if this is a 66/67 Mustang shifter or something else?

I will, thank you.