News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

Rear quarter Window Interior Trim

Started by Steve McDonald Formally known as Mcdonas, March 31, 2019, 07:18:18 AM

Previous topic - Next topic

plowhorse

I have a set from the above mentioned guy from California.
While the texture was very accurate, they were about 3/8 inch short of fitting in my aluminum quarter window frames.
For Sale if anybody wants them.

kingchief

I am interested in a set also. Please keep us posted.

Happy Holidays!

Steve
SFM 6S406

Steve McDonald Formally known as Mcdonas

Count me in as well to this "crowd funding"
Owned since 1971, now driven over 249,000 miles, makes me smile every time I drive it and it makes me feel 21 again.😎

bluemax

6S235

SFM6S

I would buy a set and prepay as well.

Joe

Doug C


Chad

I will keep you guys posted.  It is going to be a three month process.  So that is what the maker is telling me so that means 4 months.
Chad

Cjc6566

I  would love a set and willing to pay in advance and contribute to tooling-

Thanks

Cory James
owner of 1604 Hertz / Portland Oregon

Doug C

Quote from: Cjc6566 on November 23, 2020, 08:24:35 PM
I  would love a set and willing to pay in advance and contribute to tooling-

Thanks

Cory James

I would also assist with some dollars if needed.  Doug C

Doug C

Quote from: Cjc6566 on November 23, 2020, 08:24:35 PM
I  would love a set and willing to pay in advance and contribute to tooling-

Thanks

Cory James

I would also assist with some dollars if needed.  Doug C

s2ms

These things must have started warping almost immediately. I have a photo of my 66 interior taken in 1973 by a friend of the owner at the time showing the trim , looks exactly the same as it does today....wavy.
Dave - 6S1757

Bob Gaines

Quote from: s2ms on November 24, 2020, 12:25:29 AM
These things must have started warping almost immediately. I have a photo of my 66 interior taken in 1973 by a friend of the owner at the time showing the trim , looks exactly the same as it does today....wavy.
It probably didn't take too many heat cycles for the plastic to start warping.Of course some are worse then others.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

commok

I'm definitely in, and $200 would seem to be an entirely appropriate price for quality set of 4....

C Griffith

I'd be willing to buy a LH&RH set if they look original and fit.
Saves me from making them in my shop. The best of luck to ya.

Chad

Guys thank you for all the offers in helping to pay for the tooling. At this time I have it covered.  The tooling cost will dictate what the price of the pieces are.

Thanks
Chad