Rocker arm help

[6s855]

I'm replacing the Poly lock rocker arm nuts on my 289 hipo with a set of old-school rocker arm nuts because they're too tall for my valve covers and I hate them. I might only have 150 miles on them total.

When I removed them I saw that the diameter of the tapered rocker arm fulcrum "washer" under the poly locks was bigger than the diameter of the old-school fulcrums I was going to use.

So the question is can I reuse the bigger poly lock fulcrums under the old-school nuts or must I replace them with the smaller old-school fulcrums because the bigger ones are unique to the poly locks.

Any advice from the experienced engine builders here? Please help.
PS. I know about the old-school nuts losing tension. These are brand new.

[pbf777]

     Your choice of wording has me somewhat unsure of what it is your dealing with, so if you wish, you may call me (407-843-3673) and I will try to help you.   

     Scott.

[6s855]

Scott, you've answered my question. Much appreciated.

Jay