Reverse lock-out pin

[chipchambliss]

Can someone tell me if the pin in the attached photo is correct?  When I bought the car it had electrical tape wrapped around the upper end of the shifter to keep the holes plugged.  I wasn't sure if they had the wrong pin in there to begin with because it pops out easily.  Is it typical for the reverse lockout handle to rattle a lot?  It's metal on metal between the two pieces and it seems like there's quite a bit of space...

Thanks!

Chip

[Coralsnake]

Upon further review, Chip, there might have been a bushing inside lockout? I will direct you to a "guy"

[Coralsnake]

Bill Heeley 301 774 6710 in the Maryland

[Bob Gaines]

Bill Heeley 301 774 6710 in the Maryland

And a very good guy he is.

[The Going Thing]

Bill did my shifter and disassembled my lever so I could have it re-chromed and reassembled it.  I highly recommend him.