Topics

Here is a rebuilt 1968 1969 302 water-pump with cast iron impeller.  Marked with C8OE-D.  Will fit other applications.  $200 plus shipping located in california.

Thanks,

Tim

I have had this transmission for a while and I don't have any projects for it.  It is a RUG N1 Close Ratio 289 small block transmission.  It is not VIN stamped.  Comes with linkage,  no sharp or missing teeth.  It appears to shift easily by hand.  Would recommend a rebuild.  $2000 best offer.  Located in california 94550. Prefer not a ship if possible.
Thanks

Tim

1966 Shelby Tachometer with tapered RPM needle.  This not a replacement tachometer.  It was just reconditioned and recalibrated.  This is set up for a standard dual point distributor.  $1700 plus shipping / insured.
Located in California

Thanks,

Tim

Nice used pair of 289 Cobra powered Buddy Bar covers. For 1965 and Early 1966 Shelby GT350. Nice clean pair with no damage. I wasn't able to post more pictures. Can provide more pictures upon request. $850 plus shipping.  Located in Northern California.
*****SOLD******
*****SOLD******

Hello,

Looking for 289 Hipo heads dated around May to June of 1965.  Would prefer non ported or non polished heads.   

Thanks for looking.

1967 289 C7 hipo Heads non-thermactor emissions, rebuilt with hardened seats, does not look like heads have been ported.  D 19 cast into corner of both heads, SOLD

289 Hipo Balancer C3OE Date code E3.           $400.00
289 Hipo Balancer C3OE Date code L3.           $400.00
289 Dual point distributor with oiler C30E-12127. Date code 3JE.      $850.00

Parts are located in Northern California about 60 miles from San Francisco.
Pictures will be provided on request.

Thanks,

Tim

Looking for 9" rear end snubber plate for 1965-1968 mustang.  Virginia Mustang used to sell them, however they have no stock at this time.  This is spot welded to the floor of the vehicle.

Hello,

Looking for 289 Hipo heads dated around July to August of 1965.  Would prefer non ported or non polished heads.   

Thanks for looking.

Here is a 289 Hipo / K code counterweight / hatchet with new Cloyes timing chain set for 1965-1967 mustang.  The lower timing gear has been machined to accommodate the hipo counterweight, just like an original gear.  Price is $250.00 plus shipping. 
If interested Email: eemillers1@gmail.com thanks

Here is a set of 289 hipo heads for sale. Date code on the heads are 4H3 and 4G23 and marked 19 and 20 on the corner. These heads are complete and with springs, valves, screw in studs and push rod guide plates. They came off of a running motor.  Date code is too early for my project.. Price is $1500 plus shipping. Email tscarano1@hotmail.com for pics if interested. Thanks.

one 289 hipo head for sale date code 5K19.  $600

email:  tscarano1@hotmail.com

I have a set of 289 hipo heads that I wont be using.  They appear to be standard, no porting or polishing.  Date codes are 4G23 and 4H3.  $1800.00 plus shipping located in northern California.  Would be willing to work out a trade with date coded 5H hipo heads.  email:  tscarano1@hotmail.com.  I have more pictures if needed, I could only post 4.