Messages

According to the edition of the registry I have, 5R097 was wrecked and re-bodied. There is also  talk or sightings of a clone being raced in Europe with a 097 stamping. There is also a mustang (I'm assuming a clone) with the same number here on the west coast.

It would be highly advisable that your friend do his due diligence and check the Ford VIN of the car that's being presented to him against the confirming numbers with Howard Pardee.

The registry, also states the there was nothing left of the original chassis. 097 in my opinion should be classified as a "Known Destroyed" unless the Ford VIN numbers come back matching what Howard has.


Cheers,
~Earl J

SOLD

The 3/8" are SOLD

1/4" is left.

~E

SOLD

More pics

~E

Hello folks,

I'm re-posting this as my original post had the wrong information. Thanks Cory and Dave.
Back to my early start of spring cleaning.

Original S2MS 9424-A Intake Manifold
These were found on the Later 66 GT350's where the lower corner of the A of COBRA next to the distributor was modified or ground for clearance.
Offenhauser stamped on the underside
Heat shield in place
I believe the original carb studs (I could be wrong)
No stripped holes, no repairs, no helicoils, water corrosion is minimal
No modifications no porting
All mounting surfaces are good.

$1500.00 plus UPS Shipping whatever that is.

Cheers,
~Earl J

SALE PENDING/Sold

SOLD

SOLD

Autolite BF42 Star spark plugs box of 10 new in the box.

$100.00 plus postage.

Cheers,
~Earl J

This Lakewood scatter shield I had fitted/trimmed and clearanced for a set of headers. It had been cad plated silver.
You can see where it mated to the block on the block plate. I had it trimmed very close in the starter area.
There is an extra set of holes for a T5 transmission if you choose. I used it with a top loader.

$250.00 plus UPS shipping

Cheers,
~Earl J

Someone was asking for these I think not too long ago.
Anyway, no hardware.
One has a little hole/tear/chip see pic
Can use a good cleaning, good for a driver.

$40.00 + postage.

Cheers
~Earl J

Here are three (3) 65 GT350 steering wheel center caps, all reproductions, used and with patina.
Left to right.
Aluminum one I got from Cobra Automotive, middle one is used, right one is cracked chipped and a bit rough.
All 3 $75.00 +USPS shipping

Cheers,
~Earl J

This is a Crane Solid Roller Billet cam, Crower solid roller lifters and hardened pushrods. The cam is from Crane's Compucam series. This is a used setup I got from Curt Vogt at Cobra Automotive. He mentioned that it was removed from a street driven car. Cam spec sheet is included. New this sells for over $800+
A lot of life still with this set-up

$250.00 plus shipping

Cheers,
~Earl J

More pics

~E