Messages

Thanks for sharing. Totally enjoyed watching this!

Just sent you a PM...

These are no longer availible from Branda or their supplier.

I have received two replies to want ads that I have posted. One was from a guest user; the other from a brand new member. The text in both replies was identical and refered me to a non-member email address. I replied to one with a bogus technical question and the reply I got was "yes, that's what I have". If a moderator wants to PM me I will share the user names.

Be carfeul out there!

FOUND Need console insert, top seal below radio, complete lid or embossed covering, source for correct material to re-cover sides/rails. I have a good upholstery shop that can match the stitching. Would consider complete console if there is one out there.

Sound advice.

"when all else fails, read the instructions"

Thanks - didn't realize they were numbered and there's a nice clear picture in the shop manual. All set!

I'm installing a set of Kevin Marti ignition wires. Wondering if anyone has a picture of the correct routing, over/under etc and which cylinder gets the wire with the sleeve and angled plug? All my searching has only found picures with air cleaner installed. I've managed to make it look pretty but would I like to get it correct.

Found one.

Perfect thank you!

I am using the Holley/S7MS combo.

I'm putting together my J code and have a few questions on assembly:

1. The AMK bolt kit has 4 studs and 8 bolts. Location of studs? What color are bolts; painted, natural or black phophate (as shipped)?
2. Carb spacer: natural or painted?
3. Valve cover bolts - natural or painted?
4. Tstat housing & bolts -natural or painted?

Thank you,

Looking for preferably rebuilt or a functioning used. Thanks.

Contact for Tony?

Thank you fellas for the quick reply!