Topics

Should a 67 GT350 air cleaner base have a fitting for pcv hose connection? Thanks. B

Going through a 289 I put together many years ago that has a B302 windage tray set-up. What are the correct grade, length and washer configuration for Boss302 windage tray mounting bolts. Have the correct main cap bolts with 5/16-24 tapped holes. Originally assembled with some parts store Grade 5, 3/4" long, with split locks and flat washers.  The Monroe book says 35-40 foot lbs. Got up to 30ft-lbs but and it just didn't feel right so I figured better to make sure I have the right hardware. Seems a little on the heavy side. What say those who with experience in these matters? Thanks. Brian

Just did a post and the picture that I linked from my gallery came out as big as a bed sheet. Are there any tutorials on how to resize images. Thanks. Brian

Has anyone ever seen an original 67 inboard headlight grill with the mesh off center like the one in the picture? Part has been with car since I bought it in early 1982. Car does have some front end history so wondering if it's an actual Ford/Shelby replacement part or early repop. Thanks Brian

I see that the 15x7's are offered with 3.75" backspacing while the Shelby Magstars have 4.125" backspacing. How would the 3/8" difference affect tire selection and fit with respect to wheel well and fender clearance? Thanks. Brian

Would a service replacement 289 Hipo motor, circa early 70s, have come with Boss302 rods or 289HP rods. 289HP or 302Mexican block? Thanks. Brian