Messages

Larry Megibow owned the Glass Car Company in Butler NJ which was the other end of the state from Larry Zane. Yes, he's the one who had the collection of Cobra's and Corvettes and sold cars on consignment.

I second Jesse@shelbyparts.com. He did my calipers recently and highly recommend his work.

Looking for 1 or 2 new old stock C7ZZ-6038-E motor mounts for a 67 GT-350. Thanks

I had all four control arms restored by a reputable business in the Mustang/Shelby community using reproduction boots. All four boots disintegrated without the car ever moving. I heard the story of the ring diameter clearances, but I believe the composition of the rubber could also be a factor. I would use NOS boots if at all possible.

Could A.O. Smith have had a facility in Shelby Township Michigan at some point in time?

PM sent

Yes, a one owner car who purchased it new from Gotham Ford.

Harold Hartman original owner. NJ car.

Larry Zobeck did mine. Also repairs fastback rear side interior panels. He's located in Michigan.

Found one. Thanks Ben!

Looking for a single NOS ball joint boot. C7OZ-3A105-A. Had bad luck with Carpenter repros. Thanks

Revised price

New old stock 1969-70 351 Windsor Autolite starter motor. Ford part number C2OZ-11002-B. Engineering number stamped C7AF-11001-B. Dated 9B27. For auto trans cars. Has some paint loss here and there. Great for a survivor car. Additional photos available upon request. $495 plus shipping.

I ran 245/60/15's on a 69 with lowered arms and never had an issue.

Found one. Thanks Bob G.!