News:

We have implemented a Photo Gallery for hosting images right here on SAACFORUM. Check the How-To in News from HQ

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Shelbypat

#1
Here a NOS black glued with part number you can barely see.

Patrick
#2
Wanted to Buy / Re: 67/68 driver door
August 27, 2024, 05:41:17 PM
I am still looking. I would consider a NOS skin at this point

Patrick
#3
Wanted to Buy / 67/68 driver door
August 25, 2024, 09:09:44 PM
Hi all. I am looking for a good original driver door for 67/68.

I am in Canada but I have several contacts/adresses in USA if needed.
Join together at Ford Carlisle 2025 could also be an option if shipping is an issue.

TKS
Patrick
#4
Wanted to Buy / 428 cobra jet emblem ( found )
August 03, 2024, 08:12:35 AM
Looking for only one "428 cobrajet' fender emblem for 69/70 New or in perfect condition. (found)

TKS
Patrick, Canada
#5
Ok tks for reply...

Patrick
#6
Hey Jason. I didnt know you were the hood guys's story when we get together last month!!!! My hood part number is gone on mine. let me know if the one in your old hood frame is savable.

Patrick
Canada
#7
Parts For Sale / Shelby 69 500 air cleaner base
May 25, 2024, 09:37:14 AM
T-Bird 67 air cleaner same as S9 500. Nice piece with surface rust. You need to take the baffle off.
400 bucks.


I will be at Carlisle Ford show next weekend. So I can bring it there for free.

Patrick
#8
Parts For Sale / Re: 428 SCJ crank
May 23, 2024, 10:28:54 PM
Sold
#9
Parts For Sale / 428 SCJ crank (sold)
May 23, 2024, 08:10:46 PM
Very good 1UA crank. It is ,030 rod ,030 main and dont need to be recut. Engine has run low mileage before being disassembly.  it has been balanced to different rods weight than leman. So it would need to be rebalanced to original if you want to used leman rods.

I will be at Carlisle Ford show next weekend so I can bring it there for free.

Asking 400 bucks

Patrick
#10
Remove the ashtray, remove the 2 screws  and pull the top part rearward as there are fragile clips at front.

Patrick
#11
Top of console only and it clear.

Patrick
#12
If you replace that wire be sure to respect the length otherwise you would modify the resistance.

Patrick
#13
Yes exactly. You removed the original green/red 16 gages. Fold it and tape it. Install the intermédiaire one green/red 14 gages wire at the brake switch as 6 bulbs brake light pull more load.

Patrick
#14
Hi. Your harness is not correct. The brown ground with eyelet should be part of it. 3 pins connectors.

WCCC and Branda supply them

Patrick
#15
Hi... Can someone give me a pic of the rear side of the gas cap supplied in the recall on GT500 ?
I have the front not the rear.

Patrick
Canada