SAAC Member Badges are NOW available. Make your request through to validate membership.

Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Peter L.

  Haha, thanks Pete.  :)
 Cast aluminum for an iron bellhousing? Hmm...
1968 Shelby GT350/500/500KR / Bell housing finish
April 17, 2024, 11:56:30 AM
  Finally seeing some light at the end of the tunnel for KR 4052.
Quick question. What finish should be on the bellhousing (4-speed)? Were they painted with the engine, installed after, partial overspray?
            Thanks, Pete.
 While we are on the topic, do I need any kind of lube on the seal prior to pulling the rope from around the outside? Dish soap or silicone spray or anything like that?
   Thanks, Pete.  :)
 Getting ready to install the windshield in my KR. Can the molding clips be installed after, or do they have to go on before the glass is installed?
       Thanks, Pete.
 I have been running a Centerforce clutch behind my Cobra Jet for years and highly recommend it. The ease of pedal effort alone is worth it. I have a '69 Fairlane Cobra and those cars use a weak 2 piece equalizer bar in the clutch linkage. After many broken/ welded pieces I finally went with the Centerforce and have had no problems since.
 It's just a driver.
 I prefer my vintage 1951 Shelby bike. lol
  14" x ?
1968 Shelby GT350/500/500KR / Re: VIN tag rivets.
December 21, 2023, 08:00:15 AM
  OK, thanks Pete!
1968 Shelby GT350/500/500KR / VIN tag rivets.
December 20, 2023, 03:37:32 PM
 What style rivets were used for the VIN tag on the dash of a '68? Are they the same as the ones used for the Shelby tag on the inner fender apron?
                 Thanks, Pete. 
The Lounge / Re: Snap-on tool identification
December 13, 2023, 11:12:56 AM
 Hmm... perhaps.  ???
The Lounge / Snap-on tool identification
December 13, 2023, 10:31:22 AM
  Found this Snap-on tool in the trunk of a parts car. Can anyone identify what it is used for? A google search of the part number didn't help. Got me stumped. LOL.
Appeals / Cobra Jet camshaft recommendations
November 28, 2023, 04:39:17 PM
  Hi guys. Looking for input on a stock replacement camshaft for my KR. Any ideas? ( 4spd. with A/C )
                      Thanks, Pete.
The Board Room / Re: sticky topic
November 14, 2023, 12:09:30 PM