News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - highland green

#1
ok, i have a C1AE 6A301-B add on pulley, seems to fit a harmonic balancer with single pulley C4AE-6316_E. what are they for ?427? Bought years ago in box of 427 parts. Thanks in advance, you guys know your stuff!
#2
1968 Shelby GT350/500/500KR / Re: glass seals
January 13, 2025, 09:46:10 AM
i used steel rubber products on my 68. the windshield and rear window gasket were sourced from Branda. This was several years ago.
#3
Regional Shows and Events / Re: MCACN 2024
November 25, 2024, 02:29:15 PM
I have found some video of the show. Most show a strong group of Mopars. I know the GTO was celebrated this year, but there seems to be a small group of Ford powered cars. I would liked to have seen more,as it was Ford that had the Total Performance Program, which was a big part of the muscle car period. . jmo
#4
Regional Shows and Events / Re: MCACN 2024
November 24, 2024, 01:23:43 PM
are there many Shelby s? Did the 69 playboy car show up as was rumour.
#5
SAAC-49 / Re: SAAC 49 Images
July 26, 2024, 07:25:40 PM
thanks, so much! ;D
#6
Was the photo staged? Publicity for who? Or an actual event. ???
#7
Do 1969 G.T. 500s use a single or dual vacuum distributor? Thanks in advance
#8
Branda #SBKt10, $19.95, 1968 front plate bracket
#9
Branda sells them or used to sell them. I have a repo from him some where.
#10
pm sent, only have 6
#11
i have 6 of the screws, i belive 64-65 t-bird the same.  where are you located, Im in Sask
#12
use a new gasket. i cant recall needing any lube, but if you do dish soap and water will work. me and a friend did mine.
#13
1967 "A" scratch on back of block, no reinforced webbing on mains. "C" scratch production didnt start until July ?? I dont think 1967 Shelbys received "C" scratch blocks. Others will know more.
#14
235 x60 /15 all the way around, 68, gt500
#15
1968 Shelby GT350/500/500KR / Re: KR tilt mechanism
September 23, 2023, 11:56:37 AM
Thanks Jack. my tilt would not move all of the time. After reading your post. I took a 1/2 inch length of vacuum hose and forced it over the signal leaver. It did the trick.