Topics

Car built 12/5/67. What would be the appropriate date code on a a voltage regulator?

For those 68 Shelbys requiring a front license plate, what have you used to install the plate bracket without drilling holes. I purchased a bracket from Tony Branda supposed to hang underneath the bumper, but I'm not seeing any way to hang

Early Dec 67 car. I cannot start car unless I gently fiddle plastic pin for cable that goes to vacuum motor that actuates tilt away option.

It was working fine until car sat for awhile due to weather.

My question - is there a way to permanently fix this? Cable adjustment? All original tilt way components seem intact.

Was trying to add a pic?

My 68 GT500 Holley carb developed small leak at bottom of secondary bowl area passenger side - surprise!  It drips right on top of intake where engineering part number is for about fifteen minutes after I turn off engine - about 1/2 oz. The car starts right up, idles smooth and engine strong but strong gas smell after shut off.

Carb was fully rebuilt by reputable shop few years ago but car sat awhile.

What is different? recently had carb tuned and transported from Texas to California. I found small screw sitting on the intake but I'm not seeing any screws missing. 

Wonder if it's simple fix.

I understand there are long screws that attach console to the floor and I have all those but what is missing are the screws that hold the actual lidded console/liner part? Is it the same type of long screws?

What is the correct woodgrain type for the door pull end caps.  What is on the car and other unmolested car looks different from all the other interior woodgrain?

Reminds me of the Cougar burlwood.

Seems like every Mustang or Shelby I have purchased radio is always disconnected especially if car has been sitting. Specific to my GT500, is it easy to connect radio from underneath dash or does console need to be removed to connect radio?

Can you please point me to information re: ownership update info 68 gt500 #444. Thanks!