Topics

Up for sale a refurbished early 1967 power steering control valve with the early 1/4" pressure port.  End cap dated September 6, 1966.  All new seals, ball stud and sleeve. All natural finishes, no painted surfaces.  Correct for all 1967 V8 Mustangs including GT 350 and GT 500.

$350 plus shipping obo

Thanks
Jon

DP-6 points pair in Autolite star boxes $125
DC-6 condenser nos in Autolite box. $25
DR-5 Autolite rotor nos in Autolite box $95
C6AZ-6A666-A EV-8 PCV valve nos in Autolite box $45

More available, but limited on the dp-6 points.
Prices obo

Thanks
Jon

Up for sale NOS in boxes chrome plated 1967 Shelby Mustang GT 350 trunk/grille/dash emblems. Perfect for concourse restoration.

Have only seen a few for sale in the last 25 years.  Repos are chrome plated.

Sold to TL

Thanks
Jon

Up for sale a nice used original 1966 Ford High-Performance supplemental manual, booklet.

Great condition except for partial slight tear at top right as seen in photos.


Sold  to Trent

Thanks
Jon

Up for sale a nice original 1970 Shelby Mustang owners manual. Unfilled out with no writing inside.  Some slight wear and color fading on cover.

SOLD to MS

Thanks
Jon

Were the lower exposed pan head screws at the bottom of the fiberglass spoiler end caps originally Phillips or straight slot screws?

AMK supplies Phillips in their kit, but verifying that is correct?

Thanks
Jon

Up for sale an NOS set of Dietz upper scoop lights.  Marked DZ in oval with numbers 77-823.


Sold to GR

Up for sale an NOS Motorcraft DP-6 point set pair and DC-6 condenser.

$old to SM

Up for sale an original 67 power steering dipstick with check with oil hot on handle/loop.  Driver/ survivor condition. 

Not sure if these are 67 only or also good for 68's?

$60 plus shipping

Up for sale a very nice original heater motor shield for the engine compartment. 

Correct for big block and some small block applications I'm told.

Stripped, primed, painted and ready to install.

SOLD!

Thanks
Jon

Up for sale a newly rebuilt C6OE-A cast iron water pump with Ford Racing Boss 302/ 289 hipo impeller.

New back cover and attaching bolts from dead nuts on. 

Perfect for your 66-67 289 Hipo Shelby or Mustang.

SOLD!!!

Thanks
Jon

Up for sale an NOS set of correct lenses for your early 1967 Shelby.

SOLD!


Thanks
Jon

Up for sale a nice set of used 302 Mexican thick main caps like 289 Hipo.

SOLD

Thanks
Jon

Up for sale an NOS 67-70 group 24 battery tray.  Original finish with Ford stickers. 

SOLD

Thanks
Jon

Excellent used original Bakelite 67 4 speed shift knob for sale.  Must have been an early take off.  Not restored.

SOLD!

Thanks
Jon

Up for sale an NOS pair of ventilated DP-6 points with gray insulators (fomoco stamped), printed Autolite logo DR-5 rotor (not raised letters) and DC-6 condenser.

$175 plus shipping obo

Thanks
Jon

Up for sale a really nice used 4 speed shift knob and mushroom nut for sale. Very nice early take off condition.  Not restored.

SOLD

Up for set a nice set of original 289 hipo main caps with correct C3OE-A rear cap.


SOLD!

Thanks
Jon

Anyone have an extra original marked/tested 289 Hipo crankshaft?  Standard or not overly turned. 

PM if you can help

Thanks
Jon

Early take off original 67 4 speed knob.  Excellent original condition, not restored in any way.

SOLD

Thanks
Jon