Messages

Here's another possibility. Difficult to find a spec on the nut size.......

https://www.dennis-carpenter.com/cars/exterior/antenna-amp-radio/6a-18817-s-antenna-lead-in-wire

Found an old "Snyder" auto antenna on ebay

https://www.ebay.com/itm/174611195363

Wonder if that coax cable and connector/nut is compatible with the PM300 stalk.

Thanks for the response Bob. I saw that one on ebay. It's also missing the coax cable lead, nut, and metal strap.

Looking for a 1969/1970 Shelby Antenna (C9ZZ-18813-C)

Guessing the seller made a big mistake making the auction "no reserve"...........

Found the 3 into 1 at Branda...........

Bob, Coralsnake,

Thanks for the replies. Haven't been able to locate either the 2 into 1 or a 3 into 1 bullet spice connector. Any idea where I can find one?

Need some help with connecting the 2 license plate lamp sockets to the wiring harness. Should the 12V contact wires from each socket be spiced together into 1 bullet connector that plugs into the harness, or should the loom have 2 female bullet connectors for each socket? Similarly, should the ground wire with the lug connector from each socket be spliced together into 1 lug terminal or should each lug terminal be connected to ground? Thanks!

Looking to "rent" or buy the O-K stamp for 428CJ valve covers. Dead Nuts On is out of stock.

Try unplugging the black wire from the slide switch to the glove box switch to see if that has any effect..........

Looking for a 1969/70 deluxe interior map light assembly.

Thanks Patrick. What's the trick to remove (or back up an inch or 2) the top part?

Does the console need to come out to remove the radio bezel? Unless I'm doing something wrong, there doesn't seem to be enough clearance for the 2 protruding bolts on the back side of the bottom part of the bezel to clear the console.

That helps a lot! Thanks Patrick

Bob

Whoever restored the lower right dash on my 69 GT500 did not include the belts or park reminder lights. After many months I was able to locate and purchase both lights/bezels and wiring. Can someone  please provide the proper dimensions for locating the bezels? I need the dimensions from the bottom of the park bezel to the bottom edge of the dash and the distance between the bottom of the belts bezel to top of the park bezel. See attached pic. Thank you!