Messages

and more

more photos

Selling my '89 Saleen. This is not for the purist..

It's got 50k or so original miles, original paint, no rust, the original seats are gone, but the Saleen steering wheel, instrument cluster and door panels are there.

The original wheels and drivetrain are likewise long gone. The motor is a 347 stroker with a Paxton built by Coast High Performance in Southern California. The heads and intake were ported by Foxlake in Ohio. Cam and blower set up to run 16 to 18 pounds of boost. Trans is a TKO. When raced the car ran 7.1 at a tick over 100mph in the 1/8th at 4000 feet above sea level and ran in the 6's at sea level.

Car is in Oakland, California with Jack Schroll and have a clean title.

Drive as is, or restore.

Asking $17.5k or trades on classic cars/Shelby parts/motorcycles..thanks!


https://youtu.be/-3n_QlQ_E0M?si=TNRoYUKXYqxF8nEU

https://www.facebook.com/share/v/18WcfWqx36/?mibextid=wwXIfr

Got a set of headlights but still looking for a 15x6 steel wheel for a '68 car...thanks for any leads.

i'll take it--pm sent!

Looking for a 15x6 wheel and a set of headlights for a '68 Mustang..thanks for any leads!

pm!

I texted the seller & he's asking $200k or trades..whew

Thank you!

Thanks so much!

Thanks again for the help with my old spares.

The last other items I found in the garage are these below. Is this an AC pulley and do the numbers denote a date of any sort?

Thanks again for your help!

Thanks so much for the comments.

The list 4780-2 carb came off my '68 GT500 which in fact didn't run right until I switched the carb and now I recall the bell housing came off my '67 GT500..both cars are since long gone. ☹️

Bell housing

I sold my '68 Shelby GT500 some time ago but found the old Holley and bell housing off the 4sp; worth anything or are these basic Ford parts?

Thanks for any help!

Looking for a driver to Saleen fox body Mustang...thanks for any PMs!