Messages

Looking for an oil cooler block adaptor for my April 1969 build Boss 302 (prefer '69 but okay with '70).  It did not have one originally, but I have the rest of the setup and would like to install when I get it back on the road/track after 48 years of sitting in the prior owner's garage.  If it's part of a complete setup, that would be fine too.

I am looking for a set of boss 302 or 289 hipo connecting rods.  Please let me know if you can help!

Looking for a Hipo autolite 4100 for CSX2225 from the October 1963 to March 1964 time frame. Please let me know if you have one to sell!

Also looking for a 4 barrel iron manifold from the same time frame.

Here it is, he just dropped it off.  Obviously the shifter is aftermarket.

289 Cobra T10 trans were typically all aluminum weren't they ?

Cobras (any engine) used cast iron cased C3AAH transmissions until just before the middle of the CSX2101-CSX2200 group. That is street cars. Shelby American also registered a few custom special gear set transmissions with the Fédération Internationale de l'Automobile (F.I.A.) race sanctioning organization for Cobra roadsters from early on. The mystery time frame for production Cobra case materials was roughly between when iron cased standard Ford units were used for CSX2115 (completed as a car June 1963), CSX2125 with iron cases, and  the special Cobra transmissions with aluminum cases that appeared by the time CSX2136-2138 were completed (completed as SAI team race cars about August 1963). CSX2126 would NOT be in the discussion because it was finished before CSX2080.

Dan - What is your view of the Sebring cars (CSX2127-CSX2129)?  Did they originally use iron or aluminum T-10s?

I am looking for a good 28 spline main shaft for a mustang or falcon T10. 

Thanks
Mike

Looking for 4 '63 original/NOS galaxie swaybar end links as used on 289 comp cobras.  These have double threaded ends and are forged with integral stops for the bushing washers.

Thanks!

Still looking for an original opposed manifold...........

Any leads out there for original Kidney  Bean wheels.....

Probably a long shot, but don't know if you don't ask...Anyone have a set of 1960's magnesium 6" front and 7" rear Halibrand kidney bean pin drive wheels you would sell?  Thanks!

Mike

Looking for a c3of dual points hipo distributor for a 289 hipo.

Also looking for single groove pre-65 pulleys 289 (water pump and crank).

Thanks!
Mike

Thanks for all of the replies!  I was able to buy one this morning.

Any standard/standard cranks out there for sale?  Please PM me if you have anything for sale!

Thanks!

I texted you.  Let me know if you didn't receive it.

Still looking for a manifold.  I would trade an original 60's parallel manifold plus cash for an original opposed manifold!

Looking for 1960's 7mm Autolite spark plug wire in orangish/tan.

Thanks
Mike