Messages

I sent my to Holley and it came back very nice.Looks like new.

I am trying to find a transmission for my car. I am not sure which trans is needed for my 1967 Shelby GT500 with Ford production date of February 13, 1967. I was told it should be a RUG S. tag but I only see that for 68 500. Does anybody know the correct case number, tail shaft housing number and correct tag? Also the correct Bell housing number.

USA

WTB Original intake C7ZX-9425-A
Also need C6ME-A 428 Block/short block. 6M Date code. December 66.

I just had 50 sets made. Have another 150 being assembled right now.
I need to get home and zinc plate them. They will be available in March.

Ok thanks for the info.

Message
I bought a 1967 Shelby GT500 years ago with no motor and trans. Trying to buy right date code parts.
Ford production date was February 13, 1967.
Getting a lot of different information. First off is engine block. Look like block date should be no more them two months of production date of car. So December 66 to February 67correct?Also A on back of block with reinforcement webbing to be completely correct for a 428 police interceptor motor?'
Also cylinder head, identification numbers, and date codes?
Looks like only one intake manifold option. 2x4.
Also exhaust manifold. Look like 390 GT manifold. 66/67 year.
A lot of the engine blocks are not reinforced that I have been seeing and I don't think that's right for this car. I know you cannot tell the difference once it is in the car as long as I have the right gate code.
AnyInformation would be great.
Thanks Rick.