Messages

BTT

PM sent


Tim

The studs I think are called "Trim Rivets". The ones I have are made by Spitznagel.  They also make the stud gun to apply the rivet with a special tip.  This is kinda of an expensive set up for just 5 rivets.  The gun alone is around $300.  Eastwood may have a cheaper solution.  It is possible just to drill a hole and use a sheet metal screw.  I don't like this because water can seep into the threads, might be able to seal with silicon??  This is also not a factory repair.  Maybe somebody has stud gun locally that can be borrowed.

Tim

Here is a set of hipo main caps that are on craigslist.  They appear to be correct especially the rear cap (C3O E-A).

https://sfbay.craigslist.org/eby/pts/d/pleasanton-ford-289-hipo-code-main-caps/7248941562.html


Regards,

Tim

Here is a 289 Hipo / K code counterweight / hatchet with new Cloyes timing chain set for 1965-1967 mustang.  The lower timing gear has been machined to accommodate the hipo counterweight, just like an original gear.  Price is $250.00 plus shipping. 
If interested Email: eemillers1@gmail.com thanks

I had two 289 Hipo distributors rebuilt within the last two months by Dan Nolan.   Here is his contact information.

Daniel Nolan
Mustang Barn & American Classics
651 Sumneytown Pike
Harleysville, PA 19438
215-723-3722
dan@mustangbarn.com

Regards,

Tim

Hello

PM sent on the 1965 mustang parts.

Tim

FYI
Seen this on craigslist in the Phoenix area.  (not mine)

1965 1966 Shelby ford mustang 1''sway bar factory - $750
condition: good
i have a factory 1965 1966 ford Shelby mustang sway bar.its used on the GT350 cars.its the 1" sway bar.this is not a repo or aftermarket.you get the sway bar and 2 NOS sway bar brackets.the sway bar needs to be restored/painted.i do not have the rubber insulators.i like 750.00 for the everthing.jon 6two3-5one6-one347


Tim

Here is a set of 289 hipo heads for sale. Date code on the heads are 4H3 and 4G23 and marked 19 and 20 on the corner. These heads are complete and with springs, valves, screw in studs and push rod guide plates. They came off of a running motor.  Date code is too early for my project.. Price is $1500 plus shipping. Email tscarano1@hotmail.com for pics if interested. Thanks.

I have a 1967 fastback marti report for Burnt Amber not sure this is what you are looking for.

Tim

one 289 hipo head for sale date code 5K19.  $600

email:  tscarano1@hotmail.com

I have a set of 289 hipo heads that I wont be using.  They appear to be standard, no porting or polishing.  Date codes are 4G23 and 4H3.  $1800.00 plus shipping located in northern California.  Would be willing to work out a trade with date coded 5H hipo heads.  email:  tscarano1@hotmail.com.  I have more pictures if needed, I could only post 4.