Topics

Might have had one plastic tab repaired.  $90 + shipping from 35801.

$250 each + shipping from 35801.

In original box. $225 + shipping from 35801

[(2)]

year/months available
$3 each + shipping (will combine shipping to reduce cost)

A (2) indicates that I have 2 copies of that issue.

Super Ford
Volume 8 - 6,7,9,10
Volume 9 - 3,4,6
Volume 10 - 11
Volume 11 - 2,4,5,7,10
Volume 12 - 1,2
1980 - 1,6,12
1981 - 3,4(2),5,6(2),7,9,10(2),11
1982 - 8(2)
1984 - 8
1985 - 9/10 (combined issue)
1987 - 6/7(2)(combined issue),8,9,10,11,12
1988 - 3,4,8,9,11,12
1989 - 1,2,3,4,5
1990 - 2,4,6,7,8,12
1991 - 2,3,5(2),6
1992 - 2,3,4,8
1993 - 2,3,4,5,6(2)
1994 - 2,10
1995 - 1,2,3,7,8,9,11,12
1996 - 1,2,4,6,7,8,9,10,11
1997 - 1,2,3,4,5,6,7,8,9,10,12
1998 - 1,2,3,4,5

Ford Buyer's Guide
1989 - 4,6,12
1990 - 1,2,3,4,5,6,7,8,9,10,11,12
1991 - 1,2,3,4,5,6,7,8,9,10,11,12
1992 - 1,2,3,4,5,6,7,8,10,12
1993 - 1,2,3,4,5,6,7,8,9,10

Good shape, center lense has some scratching near bottom corner that should polish out. $270 + insured shipping from 35801.

NOS in the box 1966 Styled Steel Wheels trim rings,  set of 4, C6ZZ-1210-A, $700 + shipping form 35801.

Rods marked D0ZA, handle needs new chrome.   $900 + shipping from 35801

This engine was in may dad's old 1962 Galaxie 500. It was an original 406 car - he bought a new short block from Woody Anderson Ford in Huntsville , AL. Has C2SE 406 heads, 406 tripower, puke tank, generator, flywheel. Has XE scratch on back of block.

He used to hook it up to a battery and turn it over once in a while but since he moved, it has not been turned over in 15+ years. Has been stored inside the entire time.

Block casting number is C5AE-A, cross bolted.

Engine is located in Huntsville, AL.

SOLD

1969 -70 Rally clock - have not checked if it works - most replace inside with digital internal workings  - $75  SOLD
1969 Fastback trunk lid, original black jade paint and all original Mustang letters. Still has decals on bottom - see pic for date code. $350.   SOLD

Parts + shipping from 35801

Found this in my stash this weekend. Is this applicable to a '65?

https://www.saacforum.com/index.php?topic=21999.0

Ad states original "restored" steel wheel. Implies original Shelby wheel, but shape looks different than other original painted Magnums I have seen

Drawing was to be held last Saturday, June 4.

In the classifieds, http://www.saacforum.com/index.php?topic=18816.0, the seller states that the car is one of 404 4 speed convertibles, but one of only 214 with a particular engine/transmission code. For '68 GT-350 convertibles, what other engine/4 speed trans combos could there be? Were there close/wide ratio 4 speeds like the Boss 302?

When was the last '66 made? In the for sale section is a T-10 listed as correct for a late '66, has a date code of 7-27-66.

http://www.saacforum.com/index.php?topic=18298.0

Seems like there would have been some delay even after the case was cast (assembly, shipping, etc.), making this available even later in the year.

Complete 5 volume factory Ford shop manual set (engine, body, electrical,chassis, pre-delivery and maintenance) , includes Mustang, Cougar, TBird, Lincoln, Pinto, Torino, Cyclone, Montego, etc.

$60 plus shipping from 35805

Nos, still very pliable, in original box. Part number C5ZZ-6342084-A. $295 + shipping from 35801.

Good shape, could be painted to match other colored interiors.

$200 + shipping from 35806.

Looked at this car in 1988. Was owned by Wayne Mills, Osage, Iowa. Painted Emberglow.

This is another I looked at in the late 1980's. Was owned by Rick See, Independence, Iowa.

This car was for sale in 1988 at P&P Performance in West Des Moines, Iowa.