Messages

T-Bird 67 air cleaner same as S9 500. Nice piece with surface rust. You need to take the baffle off.
400 bucks.


I will be at Carlisle Ford show next weekend. So I can bring it there for free.

Patrick

Sold

Very good 1UA crank. It is ,030 rod ,030 main and dont need to be recut. Engine has run low mileage before being disassembly.  it has been balanced to different rods weight than leman. So it would need to be rebalanced to original if you want to used leman rods.

I will be at Carlisle Ford show next weekend so I can bring it there for free.

Asking 400 bucks

Patrick

Remove the ashtray, remove the 2 screws  and pull the top part rearward as there are fragile clips at front.

Patrick

Top of console only and it clear.

Patrick

If you replace that wire be sure to respect the length otherwise you would modify the resistance.

Patrick

Yes exactly. You removed the original green/red 16 gages. Fold it and tape it. Install the intermédiaire one green/red 14 gages wire at the brake switch as 6 bulbs brake light pull more load.

Patrick

Hi. Your harness is not correct. The brown ground with eyelet should be part of it. 3 pins connectors.

WCCC and Branda supply them

Patrick

Hi... Can someone give me a pic of the rear side of the gas cap supplied in the recall on GT500 ?
I have the front not the rear.

Patrick
Canada

I don't know why it load upside down

Patrick

According to mustangtek

Patrick

 Should'nt donations cars to schools have commitment to salvaged them at resales ?

Patrick

Anybody has an explanation why vent is located at a different place on BB's ?

Patrick

I always thought it was for staggered shock cars and the different placement of the staggered shock. I'd have to further into my 2 cars as I have both factory rears in my GT350 vert and my 4 speed staggered shock drag pack Mach1.

Mine is automatique BB car with factory rear end and it have 2 holes.So no staggered. I have thought the reason was bigger exhaust but in a previous discussion others mention that it is same size a this section of the exhaust system...

Patrick

Anybody has an explanation why vent is located at a different place on BB's ?

Patrick

Hope this help

Patrick