What are these, where do they go, and how many do I need?
Thanks
Ron
Seat side trim spacers for 65-6, 67 std If memory serves correctly
Quote from: TJinSA on February 28, 2020, 11:20:09 AM
Seat side trim spacers for 65-6, 67 std If memory serves correctly
Confirmation that your memory is still serving you well. ;) Of course regular Mustang interior in the case of 67 .deluxe seat parts don't use that.
Unfortunately, confirmation that mine is not! LoL!
Thanks Tom and Bob. I hate having pieces left over
and found them in one of my boxes!
1 per side for std front seat trim. There were usually 2 plastic spacers/washers used on the side mounting screws also. Originals usually held in place with a little rope caulk.
+1
Very good. Back in the box they go!
What about these sticker? Trunk and hood?
Orderd them last March, but just now getting
around to them.
Thanks
Ron
Quote from: rbarkley on February 28, 2020, 07:34:38 PM
Very good. Back in the box they go!
What about these sticker? Trunk and hood?
Orderd them last March, but just now getting around to them.
Applied to most of the non-steel lined hood and trunk lids on the undersides. Often fell off and were lost or stuck somewhere else in the general (thing gravity ;) area if and when they did
Here is a link to a long earlier post with some pictures. Remember if you apply them within range of the exterior paint overspray they should have paint over the stickers (applied before the painting took place by the supplier) in logical manner/pattern
http://www.saacforum.com/index.php?topic=4916.msg42645#msg42645 (http://www.saacforum.com/index.php?topic=4916.msg42645#msg42645)