Since I have my dash and instrument cluster apart I thought it might be a good time to try and get the clock working. Is there a common cause or fix for a non working clock? Is there someone who fixes them? Are there any working clocks available for sale?
Corey
The most common cause is corrosion or just being dirty. Sometimes a good cleaning will bring it back to life. There are small contacts on the back side. There are several vendors that service the clocks, but most people just replace the mechanical movement with a new quartz mechanism. This can be done quite easily and usually takes about twenty minutes.
http://www.mustangandfords.com/how-to/interior-electrical/1610-how-to-fix-a-mustangs-stock-clock-mechanism/
Some of the details of cleaning the points, broken springs etc. or replacement with quartz movement.
One of the worst things for the old style clock movement is when you let your battery go dead . The low voltage at some point allows the points in the clock to arc and building up carbon which later keeps the clock from powering up and winding. You can easily tell a quartz modification from original by the sweep of the second hand. The quartz has a smooth sweep. The original movement has the tick tick tick sweep.
Thank you all, this is all very helpful.
The "tick tock" movement is great, try for that
Quote from: Steve McDonald Formally known as Mcdonas on January 03, 2019, 02:53:03 PM
The "tick tock" movement is great, try for that
SO, the "Tick Tock" movement is different than the "Tick Tick Tick? ::)
;D
Everyone knows that "tick, tick, tick" is a bomb
"Tick tock" is a clock
Quote from: Steve McDonald Formally known as Mcdonas on January 03, 2019, 05:57:18 PM
Everyone knows that "tick, tick, tick" is a bomb
"Tick tock" is a clock
I concur, tick tick tick = boom
Nice one Steve
I had great success this weekend getting my clock to work. When I took the rear cover off the clock it was clear I had at least two issues. First my contacts were badly pitted and secondly something was prevented the movement from moving. I cleaned the movement by pouring isopropyl alcohol (91%) over it and even let is soak for 20-30 seconds in a cup of the alcohol. Once I did that the movement started working until the alcohol evaporated. The alcohol was acting as a lubricant but once it evaporated it stoped working. Then I got some clock lube with a very fine application tip and lubricated all the moving joints. The clock then worked beautifully. Then it was time to see if the electric winder worked. I filed the contacts and then hooked up a 12 volt DC power source and it worked perfectly. I have left it hooked to the source to see how well it keeps time. After a day or two I will reinstall the rear cover and I should be good to go.
Thanks for all the help.
I've taken apart at least 40 car clocks in GMs and Fords. In most cases, a little lubricant (I use WD40) and filing the solenoid contacts is all it takes to get them going again. If they don't work, it's usually a worn out clock spring or a burned out solenoid.