Supposed to have one or two of these clips? If two, where does the second one go?
Thanks, Pat
69 has 1 but dont 68 have 2 by shifter
Quote from: Special Ed on September 08, 2026, 11:38:48 PM69 has 1 but dont 68 have 2 by shifter
You are remembering correctly . 68 has two . The first one goes on the front shift control adapter plate holding bolt as in the picture and the second one goes on the rear shift control bolt.
69 has a different shift control which explains the different mounting.
So i need to relocate as this is a 68.
Pat
Quote from: azdriver on September 09, 2026, 11:52:53 AMSo i need to relocate as this is a 68.
Pat
Your car your choice.I would suggest getting all of the 68 assemblyline manuals . The clips are illustrated in the electrical manual.
What about 67? Similar to 68?
Jon
Quote from: 1175 on September 09, 2026, 05:34:57 PMWhat about 67? Similar to 68?
Jon
I revised reply #2 . 67 and 68 are the same.
I had that wire holder clip made back in 2005 because it was very hard to find after everybody installed hurst shifters back in the day and if u dont install that clip your reverse wire can end up getting melted on exhaust pipe when not routed correctly.
Thanks,
Pat