Print Page - Fastener question 67 spoiler end caps

Title: Fastener question 67 spoiler end caps
Post by: 1175 on April 07, 2026, 06:52:29 PM

Were the lower exposed pan head screws at the bottom of the fiberglass spoiler end caps originally Phillips or straight slot screws?

AMK supplies Phillips in their kit, but verifying that is correct?

Thanks
Jon

Title: Re: Fastener question 67 spoiler end caps
Post by: Bob Gaines on April 07, 2026, 09:52:55 PM

Quote from: 1175 on April 07, 2026, 06:52:29 PMWere the lower exposed pan head screws at the bottom of the fiberglass spoiler end caps originally Phillips or straight slot screws?

AMK supplies Phillips in their kit, but verifying that is correct?

Thanks
Jon

Phillips pan head is typical.

Title: Re: Fastener question 67 spoiler end caps
Post by: JD on April 07, 2026, 11:51:21 PM

Early cars got one screw near the lowest point on the "tail" below the rear bumper, later cars gat three screws...

Title: Re: Fastener question 67 spoiler end caps
Post by: 1175 on April 08, 2026, 11:02:27 AM

Thanks guys! 🤙🏻

Jon

SAAC Forum

The Cars => 1967 Shelby GT350/500 => Topic started by: 1175 on April 07, 2026, 06:52:29 PM