In need of a rear valance for my 67 GT350. Original is too bent up to salvage and would like to keep the car with original metal. It's the last thing left to get before paint. Send email to Audia4glover@gmail.com if you have one to part out
Define "cutouts". Later cars used the Mustang GT Valence. Is that what you are looking for?
For those that may not know, and why "roddster" is asking, there were two versions used, see attached - very early cars had standard Mustang rear valance that Shelby workers hand cut openings and added '66 GT exhaust trim rings that they cut the bottom off of and later the Shelby's got the Mustang GT rear Valance that did not require the extra hand work and part.
(I think he is looking for the later version, but he'll reply)
Rod thanks for asking. The later version is what I am looking for which matches the current original valance.
Where might you be located. It is shipable but by far easier if some one who has one is close.
Columbus, Ohio and will to drive if reasonable
PM sent
David and I got this covered.