We are finally finishing up my car, and before they put the interior back into the car, I am asking that they install the ducting for the rear scoops. Unfortunately, I no longer have the original wheel wells so the restoration shop doesn't have a good guide of where the hole should be made into the wheel well. Does anyone have a some installation instructions/pictures of where the hole "should" be for the rear ducts? Not a lot of information on this that I could find in a variety of forums and the internet searches.
Thanks in Advance!
Quote from: tschwingle on March 08, 2023, 09:44:38 PM
We are finally finishing up my car, and before they put the interior back into the car, I am asking that they install the ducting for the rear scoops. Unfortunately, I no longer have the original wheel wells so the restoration shop doesn't have a good guide of where the hole should be made into the wheel well. Does anyone have a some installation instructions/pictures of where the hole "should" be for the rear ducts? Not a lot of information on this that I could find in a variety of forums and the internet searches.
Thanks in Advance!
Fastback or convertible because they are different.
The car is a Fastback.
Sorry I only have some convertibles handy.
Sorry don't have any measurements but have a few pictures I've collected and others have shared to offer. Hope they help
(https://www.concoursmustang.com/forum/gallery/18/6-090323233927-184571352.jpeg)
(https://www.concoursmustang.com/forum/gallery/18/6-090323233927-184542327.jpeg)
(https://www.concoursmustang.com/forum/gallery/18/6-090323234405-184582348.jpeg)
A couple measurements from mine.
Thanks for the pictures - will definitely help with cutting the hole in the wheel wells. Appreciate the help!