Kinda looks like I can leave the exhaust alone and slide back then forward.. anyone confirm? Thanks
Are you using a lift and a transmission jack?
short lift only about 2ft and yes i have a tranny jack.
On my car (66), I pulled if off but wasnt fun. You have to get enough height of the car to drop the exhaust in front before it touches the floor while at the same time taking care at the rear axle and valance. You also need to support the engine to control the angle. H pipes make it harder. Very difficult on mine without marring up the underside paintwork.
stock exhaust set up.
the answer is yes. Took about 2 hours. did it on my back.....
Quote from: hurlbird on February 14, 2022, 01:44:37 PM
the answer is yes. Took about 2 hours. did it on my back.....
You will have much more fun getting it back in and lined up with the throw out bearing that way .
Good for you! Now can you get it back in? ;D Them cast iron gear boxes get heavier every year.
everything is getting heavier! :(
Studs in the bell housing have helped me with re-entry alignment and weight "management."
thanks i already have them ready!!!!!!
I'm paranoid. After sliding the tranny onto studs I replace the top studs one at a time with a regular bolt making sure there's no chance it will slide off the studs...
Quote from: KR Convertible on February 14, 2022, 01:49:36 PM
Good for you! Now can you get it back in? ;D Them cast iron gear boxes get heavier every year.
There was a guy in my high school group of friends we all used as our trans jack.
Quote from: s2ms on February 14, 2022, 05:45:01 PM
I'm paranoid. After sliding the tranny onto studs I replace the top studs one at a time with a regular bolt making sure there's no chance it will slide off the studs...
I've used threaded rods for this leaving the trans on the jack. As you tighten up the nuts, it pulls the transmission in.
In one case though, I broke the cast iron hub on the clutch disc because I didn't rotate the output shaft as it was going in, so don't forget that part.
As it turns out, that is one of the battles I had with Gene at Centerforce. He treats warranty claims like it is coming out of his own pocket.
If you can though, take the h pipe off.
I need to learn the procedure for installing the engine AND the transmission together. That one is coming up for me and I keep entertaining the idea of installing that assembly WITH the headers installed? ::)
Quote from: shelbydoug on February 15, 2022, 07:44:53 AM
I've used threaded rods for this leaving the trans on the jack. As you tighten up the nuts, it pulls the transmission in.
+1. This is a great technique that I've used it in the past and while the transmission doesn't go in with a bang, it does make it possible for one person to easily do the job without strain on the body. Slow and easy gets it done. Very important for those of us who aren't as quite as nimble as we once were.
in the end it went in easy. I too used the "rods" cut from old starter bolts i believe. But i bet i spent 25% of time backing out the top drivers side rod. I thought i made sure they could be removed by hand but i guess not despite putting them in by hand. Needle nose vice grips were required to get it started with tiny turns and then i did it by hand but that vice grip action which i bet totaled less than 5 turns took forever! Oh and the tranny plug didn't work that great but better than nothing. Wished i had a real drive shaft slip end. Anyway thanks all! :)
Oh at 58 yrs that is my last on my back tranny job. No mas!
hurlbird
Tip. take a hacksaw or cut off wheel and cut a straight slot in the head of the guide studs for easy removal. If needed just use a screw driver to remove them.
Rodney
good idea ;D