What finish are the plugs for the upper and lower ball joints that came in the zerk fitting holes from the factory?
Quote from: hertz350 on December 30, 2021, 05:32:20 PM
What finish are the plugs for the upper and lower ball joints that came in the zerk fitting holes from the factory?
Bare steel.
what protective coating is used to keep parts which have a bare steel finish from rusting? a flat and satin clear coat?
Sorry to hijack thread but does bare steel apply to '68 Daerborn and Metuchen?
I have used Boe-Shield on bare metal parts. It coats them well, but requires maintenance. If your control arm ends are bare steel as assembly line, you can coat the ends, which will automatically cover the plugs. You can use a flat clear coat that will last for a while depending on your driving habits, i.e. driving in the rain.
Quote from: rraceme on December 30, 2021, 07:14:30 PM
what protective coating is used to keep parts which have a bare steel finish from rusting? a flat and satin clear coat?
Oiled if anything originally. Today a protective oil would be suggested. Clear coat will not hold up any longer than the oils we use today, it will crack, yellow or allow for moisture to enter at the treads and creep under the clear creating rust
Boeshield is often the product of choice since its affordablp and widely available
Quote from: 68stangcjfb on December 30, 2021, 08:07:52 PM
Sorry to hijack thread but does bare steel apply to '68 Daerborn and Metuchen?
Yes
Thank you!😁