Print Page - Reverse lock-out pin

Title: Reverse lock-out pin
Post by: chipchambliss on July 16, 2020, 01:28:33 PM

Can someone tell me if the pin in the attached photo is correct? When I bought the car it had electrical tape wrapped around the upper end of the shifter to keep the holes plugged. I wasn't sure if they had the wrong pin in there to begin with because it pops out easily. Is it typical for the reverse lockout handle to rattle a lot? It's metal on metal between the two pieces and it seems like there's quite a bit of space...

Thanks!

Chip

Title: Re: Reverse lock-out pin
Post by: Coralsnake on July 16, 2020, 02:01:40 PM

Upon further review, Chip, there might have been a bushing inside lockout? I will direct you to a "guy"

Title: Re: Reverse lock-out pin
Post by: Coralsnake on July 16, 2020, 02:06:55 PM

Bill Heeley 301 774 6710 in the Maryland

Title: Re: Reverse lock-out pin
Post by: Bob Gaines on July 16, 2020, 02:09:08 PM

Quote from: Coralsnake on July 16, 2020, 02:06:55 PM
Bill Heeley 301 774 6710 in the Maryland

And a very good guy he is. ;)

Title: Re: Reverse lock-out pin
Post by: The Going Thing on August 01, 2020, 02:11:15 AM

Bill did my shifter and disassembled my lever so I could have it re-chromed and reassembled it. I highly recommend him.

SAAC Forum

The Cars => 1968 Shelby GT350/500/500KR => Topic started by: chipchambliss on July 16, 2020, 01:28:33 PM