My 69 GT500 came with 2 original fenders, but it is obvious that there had been previous damage and poorly (visually noticeable) repairs attempted. The exterior looks good, but the underside and the front lip around the headlight bucket is ??????? Has anyone had any luck at finding a good place or way to correct this OR is it better to bite the bullet and purchase replacement fenders. And if repair the originals is the suggestion, does anyone know of a good place in North Georgia to perform the work?
Repait originals the back side finish is noticeably different and in center of fender u can reach up and feel the S9MS #s moulded in,
I didn't know of the S9MS #. And chance you have a photo so I can go over to the shop that has the car and look my fenders over? I am not exactly sure where to look so the photo would help
just above top center of front tire up about 5 " or so on inside front fender. Just be careful as I have seen past restorers sand off those s9ms #s on fenders hood and valance panels and that hurts the value of original fiberglass.
was this number stamped in to the material or rubber stamped on the inner fender?
raised letters moulded in fiberglass
If they are sanded off the engineering numbers are very difficult to put them back in . It can be done.