Messages

John Guyer has made them all Saac Conventions

Thanks Bob
So there were two types used?

Isn't the top pic Kyle posted a 68 CJ one?
top pic here is correct for 67? All sources show top pic for a 67 GT-500?
Thanks

Was sealant used on the threads? Or what was?

Gary,
A lot of older tire stores that have been around will mount that tire. I had my original 67 tire done at a place on M59. I had the same problem with Discount tire. I went down the street to a local tire shop and had it done.

Thanks, Pete
Much value in it?

one more

Looking for info on this manifold. I believe it's after-market? Any and all info appreciated.
Thanks

Sold

Thanks for that tip PMustang

just outside of the Detroit area, Mi

ok thanks

Anyone run into this when they bought the new C7ZX-A fan Clutch?

Have a pair of lower control arms that have been restored, not by me, that I got quite a while ago. Jim at Shelby Parts and Restoration did the rivets I was told. There is one bad spot on one of the arms. The pic makes it look worst than it is. But it is there. I ended up not needing them so going to sell them. Asking $450.00  Thanks for looking.

Sold, Sold Sold

Thanks guys
So what would be the correct fan clutch # I should have for a Jan 25th 67 build car? One I have is E C7ZE-B would that be correct?

I was able to find a E  C7ZX-A repro. Just received the part and getting ready to attach the fan when I noticed it was about a 1/4" shorter than the one I had on the car. Has anyone else gotten this part and found this? Attached is pic . I don't think it will make a difference?
Thanks everyone. Just trying to get car back up & running for rest of season and some events.

 Who makes the best repro mirror out there. My is in great shape except it comes loose and won't stay in place, the square part of it. So very annoying trying to use it to see. I've adjusted it many times but is just doesn't stay. So I thought I would get a repro to replace it. Unless I can find a really nice original one. thanks