Messages

I have a few sets as well
Let me know if you still need.

even though these are light, shipping can be extremely difficult. almost need a box 3ft x 4ft x 6in give or take

will do.
For future reference, when ever you start a post, near the bottom of the post there should be a box to check if you want an email everytime someone replies to your post

Im sorry, but after 2 days of no reply from you it was sold to someone else.
If i find another I will put you first in line

more pics

Is this what youre looking for ?

Colorado, I sent your a private message 4 days ago.
check your mail

Hello, got your PM and sent you a reply

Does anyone have a picture of exactly what bracket (or plate, or mount) that goes between the shifter body and the tail housing for a stock Ford shifter and a stock big block Toploader?  The one I have puts the shifter in a weird position, it may be for a small block?  Better yet, anyone have one to sell?  I hate to install any aftermarket shifter just because I can't find this correct missing piece.

When using the original shifter , There was never a plate for a small block car.

On a big block car  the shifter was slightly different, the reverse arm 9the one in the back) will have a slight bend towards the rear of the car when all arms are lined up tongther. Stick a phillips screwdriver shaft  or drill bit through the hole on the front center of the shifter mixing box, this puts your shifter in nuetral. Then look at the reverse arm in the rear. if its a small block shifter that arm will line up with the other 2 arms and point straight down, if its a big block shifter that reverse arm will have a bend facing the rear of the car.
Also for the bolt on factory kick back bracket to work , your shifter box frame (housing) will have an additional hole drilled that attaches to that bracket. you should see 2 holes basically on top of each other

both parts have been sold

shifter is somewhat correct  for 64 - 68 4 speed, it is a reverse lock out stick , but the pull up tang looks to be missing,
but having that 2nd hole drilled (close to the other) it is actually a 68 shifter

I doubt youre gonna find a chevy tail light panel on this site

I dont have what you need,
but if you dont find what youre looking for, and want something close,
I have 2 428CJ carbs listed in the parts for sale section.

69 Mustang / Shelby List 4279 for manual trans
69 Torino List 4345 for automatic trans

Thanks for all the feedback and pointing out the differences in the machined area for the head of the rod bolt .

Update: The rods are correct for Hipo 289 and not Boss 302

update 5/10/23

Fan is no longer available

These pics are the H4