Yea, but back in the 60's, who cared
It was called customizing back then
It was called customizing back then
We have implemented a Photo Gallery for hosting images right here on SAACFORUM. Check the How-To in News from HQ
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: camp upshur on August 02, 2019, 03:41:58 PMWhats FR power
Blair Patrick is active on the FR Power forum: CaptCobraJet.
Quote from: s2ms on August 01, 2019, 01:06:46 AMSorry Dave, I had to move the photo over with mouse to see the red arrow, my bad
Red arrow points to the test mark, a ground smooth area and punch mark about the size of BB. Orange paint duab is a HiPo part identifier.
Quote from: gt350hr on July 29, 2019, 04:09:25 PMWhere is the brinnell test mark located?
Paul ,
In THE most technical sense you need a C30E flywheel for a 5 bolt engine which came with a 160 tooth ring gear. Replacement ring gears are now 157 tooth. No problem. Yes the hi po version has the brinell test mark and "usually " an orange paint swipe along with the difference balance. The C5OE and C7ZE will interchange . If you are rebalancing the engine , a non hipo unit could be substituted. if you aren't , you would be best to use an original to get "close".
Randy
Quote from: Bill on July 27, 2019, 02:26:19 PM+1 on that!!Quote from: TOBKOB on July 27, 2019, 02:15:54 PM
I hope he had a fire extinguisher...
TOB
I hope everyone got out OK....The vehicles can be replaced, a life cannot be.
Bill