1134, black
SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: paul on April 30, 2024, 02:41:44 PMWould anyone know where I could get a dashpot. Even if not original, if it improves reliability/road worthiness, I'd be ok using one.
Thanks
Quote from: cboss70 on April 08, 2024, 02:22:08 PMI looked again over the week while I await my new repro Z-Bar from VA Mustang. Based on the comments, I do see a stop so the pedal doesn't come up beyond a certain point but don't remember a stop being on the assembly to keep it from going down too far? The functionality of the clutch itself seemed fine just the pedal overextending the main return spring was the issue. The sleeves the pedal shafts go through are fine no extra play. The clutch in there was a kit that included the throw-out bearing and it's a new Zoom one and a diaphragm type. I'll post an update when I get the new z-bar in - in a way I'm hoping mine was bent and this will solve it
Quote from: Peter L. on March 20, 2024, 04:56:35 PM
While we are on the topic, do I need any kind of lube on the seal prior to pulling the rope from around the outside? Dish soap or silicone spray or anything like that?
Thanks, Pete.