News:

We have implemented a Photo Gallery for hosting images right here on SAACFORUM. Check the How-To in News from HQ

Main Menu

part identification

Started by imming1965, April 02, 2024, 08:57:15 AM

Previous topic - Next topic

imming1965

can anyone identify what is rubber the is for? pretty sure it is for this 69 convertible but can't remember what it went with? thanks Jeremy

Special Ed

Steering column signal horn wiring harness had a sleeve that held all the wires together routing down the bottom steering  column partrly covered with that metal flat shield that attaches to bottom of column. Also another wireing  covering behind dash cluster holding wires together.

imming1965

Quote from: Special Ed on April 02, 2024, 09:56:11 AM
Steering column signal horn wiring harness had a sleeve that held all the wires together routing down the bottom steering  column partrly covered with that metal flat shield that attaches to bottom of column. Also another wireing  covering behind dash cluster holding wires together.
I agree it looks like that.... but is there any other place it might have been used. these are just a little more rubbery in feel and thicker but pretty sure they were on some part of this 69... thanks Jeremy

Bob Gaines

Quote from: Special Ed on April 02, 2024, 09:56:11 AM
Steering column signal horn wiring harness had a sleeve that held all the wires together routing down the bottom steering  column partrly covered with that metal flat shield that attaches to bottom of column. Also another wireing  covering behind dash cluster holding wires together.
+1 . I can't think of another place on a Mustang .  Not a Shelby part ether.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

TLea

We can compare length to others, when you put those pieces together what is overall length? Tilt or non tilt car?