News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

Inboards not working

Started by jdeboss302, August 21, 2023, 02:54:04 PM

Previous topic - Next topic

jdeboss302

Haven't worked in a while, so I am getting ready to dig into these.

If I am not mistaken, don't they run off the dimmer switch on the floor?

Any common areas I can easily check 1st?
Fuses?
Bad wiring?

Thx

Coralsnake

They are usually spliced right off the headlight harness.
The original Influencer, check out www.thecoralsnake.com

jdeboss302

ok, great,
but they operate off the dimmer switch ?
no internal switch ?

Coralsnake

Yes high beam switch on floor
The original Influencer, check out www.thecoralsnake.com

greekz

SFM 6S1134  '67 GT-350 #2339

Bob Gaines

The white scotch-loc quick connectors can be a source for a bad connection . You can clean and redo /improve the connections without getting rid of the historic build technique that the white scotch-loc represents.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

jdeboss302


capecodmustang.com

Joel...
When I owned #2188 they never worked...

I never drove it at night so it wasn't a big deal...

JD

See this link to a thread on this, illustration in reply #3

https://www.saacforum.com/index.php?topic=18796.msg149700#msg149700

Also attached here...
'67 Shelby Headlight Bucket Grommets https://www.saacforum.com/index.php?topic=254.0
'67 Shelby Lower Grille Edge Protective Strip https://www.saacforum.com/index.php?topic=1237.0

Bob Gaines

The easiest check is to start by using a multimeter or lest light seeing if you have power at the splice /factory headlight plug connection. If you have power there then you know it is the spice and if not then you know it is a problem from the splice on back.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

BDT 739

Quote from: jdeboss302 on August 21, 2023, 02:54:04 PM
Haven't worked in a while, so I am getting ready to dig into these.

If I am not mistaken, don't they run off the dimmer switch on the floor?

Any common areas I can easily check 1st?
Fuses?
Bad wiring?

Thx
Does the high beams work in your outboard fender lighs.  This could help direct you to the switches or wiring.

Cobrask8

Check the ground connection. I bet the fault is there.

JD

#12
Quote from: capecodmustang.com on August 24, 2023, 01:54:17 PM
Joel...
When I owned #2188 they never worked...

I never drove it at night so it wasn't a big deal...

OK if Bret is referring to the same car then you might also check that the dimmer switch is working and the bulbs are good as well, are the fender high-beams working?  (all four lights should come on when the dimmer is switched on).  Might be the dimmer is bad or not connected into the system?
'67 Shelby Headlight Bucket Grommets https://www.saacforum.com/index.php?topic=254.0
'67 Shelby Lower Grille Edge Protective Strip https://www.saacforum.com/index.php?topic=1237.0