Anybody know of a good Holley re-builder they can recommend in Knoxville TN or the E TN area.....?
Thank You,
BG
Eureka Springs AR. Jeff Yergovich.
There's only one to use for Holly's in my opinion and it's Drew Pojedinec
Thanks Craig. We talked for a bit. I'm backlogged a month and he is dealing with a generic 600MS. He found a local guy that can build it in a day.
Thanks guys..... yes Drew and I have spoken.
I am going to send him my 715 LeMans later this spring when his schedule loosens up.
For now the 600 DP will go back on later this week and I can deal with a few other small projects.
If you want it to look like new, try Joe Bunetic. He is just across the river from St. Louis. His number is 618-397-3580. He is sometimes hard to get in contact with. I think he works out of his home. I sent my original carb. off of 6S550. and when I got it back, it looked just like when it was brand new. Joe is not the man to make it run like new. Jim Cowles knows a man who can do that. Ron
Quote from: oldcanuck on February 23, 2020, 09:58:49 AM
I am going to send him my 715 LeMans later this spring when his schedule loosens up
I've been waiting three years for my schedule to open up 😂
Whatever the wait time is , Drew's work is top notch and worth the wait.
Quote from: gt350hr on February 24, 2020, 12:04:04 PM
Whatever the wait time is , Drew's work is top notch and worth the wait.
I can agree whole heartedly.
Quote from: gt350hr on February 24, 2020, 12:04:04 PM
Whatever the wait time is , Drew's work is top notch and worth the wait.
Ditto
Thanks Guys,
I'm sending my 715 to Drew a little later in the spring.
My 600 DP is ready in the morning, so I'm hoping the TN weather is conducive for a test drive later on.
Thanks to all that have responded.... I get the message !
BG