Recent posts

#1

Parts For Sale / Re: 67-68 Shelby Wheel Center ...

Last post by JD - Today at 12:05:47 AM

Mag Stars centers - the metal base - have a single top ridge and are a slightly larger diameter, the 10-spokes have a double top ridge and metal base is smaller in diameter.  The emblems are aluminum (thicker than foil) are two different diameters as well

(will try and find a photo - found a couple)

#2

Parts For Sale / Re: C5AF-E 427/Big Block dual ...

Last post by 430dragpack - May 01, 2024, 10:44:39 PM

New lower price $325 +shipping in US.

#3

Wanted to Buy / Wanted a few original 68 Shelb...

Last post by chipsdad56 - May 01, 2024, 10:03:12 PM

Hi,I'm looking for a few original 68 Shelby parts. Please let me know if you would like to sell any of the following:

1. Drivers side end cap for fastback.
2. Fog light support.
3. GT350 dash emblem.
4. Front letter panel.
John

#4

SAAC Forum Discussion Area / Re: Random car pictures

Last post by Fastbackfred - May 01, 2024, 09:54:50 PM

This pretty neat  might have been here before ?

Could you tell me more about this car? I'm pretty sure I own it now. Thanks.

#5

1967 Shelby GT350/500 / Re: issue

Last post by shelbydoug - May 01, 2024, 09:28:34 PM

There is an internal impeller that can break.

#6

1967 Shelby GT350/500 / Re: issue

Last post by Bob Gaines - May 01, 2024, 08:21:02 PM

Wondering, why power steering can sometimes be hard to steer? Belt not loose. Reminds me of newer car with rack and pinion when they go bad.

Low fluid can cause that symptom but usually followed with squealing sound out of pump. Internals of pump maybe going bad.

#7

1967 Shelby GT350/500 / issue

Last post by 67 GT350 - May 01, 2024, 08:16:23 PM

Wondering, why power steering can sometimes be hard to steer? Belt not loose. Reminds me of newer car with rack and pinion when they go bad.

#8

Parts For Sale / Re: 67-68 Shelby Wheel Center ...

Last post by 67 GT350 - May 01, 2024, 08:13:46 PM

Are these for 10 spoke or magstar?

#9

1969-1970 Shelby GT350/500 / Re: Map light stays on

Last post by DP Customs - May 01, 2024, 07:51:58 PM

Issue found: Faulty light bulb. It's a brand new LED replacement (1004 style) that's supposed to get + and - from the 2 bottom contacts, with the metal body being separate or isolated from the electronics.  In this case, the LED was made incorrectly and was getting its ground from the metal body, not one of the bottom contacts (one contact is dead/unused).  Since the bulb socket is grounded, that explains why the light wouldn't turn off.  Hope this helps anyone that runs into this issue.

#10

Up For Auction / Re: 6S305 - Bring A Trailer

Last post by SBCARGUY - May 01, 2024, 07:29:21 PM

Some recent BaT cars

6S1884 - sold for $149,500

6S814 sold for $130,000

6S1387 sold for $132,000

Not really sure you can attribute that to the seller

Since those are ALL Automatic Hertz cars....

They really do not compare in Value to a 4 Speed, Non-Hertz Car...

The seller might have done better "if" he had someone run the auction for him or... Added more photos or documented the "claims".

Based upon the information we all had... He should have taken the $175,500 (including the BAT Fee)