News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

1968 Shock Tower Covers... inne's or outies?

Started by Grouper Trooper, September 27, 2022, 01:30:54 PM

Previous topic - Next topic

Grouper Trooper

Years ago when I was putting the car together I could swear I found that shock tower cover bolts go from wheel side of apron into engine compartment with nuts on the inside. Now I cant find the info and I question my memory on the validity of my bolt placement. For something so obvious at a casual glance... = I've got to know! Head of bolts on inside of engine compartment or nuts?

Thanks!
Jayson Horadam
1968 GT 350 #1516
2 X 4 Holley's sittin' on all SCAT 331
www.mpaenforcement.com

Coralsnake

Nuts is by far the most common on 1968 NJ built cars
The original Influencer, check out www.thecoralsnake.com

Grouper Trooper

Thanks!
As I sit waiting for hurricane Ian, I'm just wandering the garage looking for stuff to do. I can mark this off my list!
Jayson Horadam
1968 GT 350 #1516
2 X 4 Holley's sittin' on all SCAT 331
www.mpaenforcement.com

J_Speegle

Quote from: Coralsnake on September 27, 2022, 01:39:21 PM
Nuts is by far the most common on 1968 NJ built cars

+1 Its a car plant specific thing. Not sure if it was due to the way the line was organized or parts positioned at each.
Jeff Speegle- Mustang & Shelby detail collector, ConcoursMustang.com mentor :) and Judge

gt350bp

It would make the most sense that the bolt threads and nuts be protected by installing to the engine compartment side.

Don
gt350bp

Bob Gaines

Quote from: gt350bp on September 28, 2022, 10:10:08 AM
It would make the most sense that the bolt threads and nuts be protected by installing to the engine compartment side.

Don
gt350bp
Maybe so but the vast majority are done the opposite way regardless of year.  Apparently not a issue ether way. Ford is not known to be a bunch of dummies.  ;)
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

Coralsnake

I dont think they really needed the threads protected, with planned obsolescence and all...
The original Influencer, check out www.thecoralsnake.com

shelbydoug

Functionally it doesn't matter which way they go. I'm sure that it is done for the sequence of assembly purposes of the line.
68 GT350 Lives Matter!

KR500

My observation over many years; 1968 Mustang/Shelby's assembled at the Metuchen NJ plant had the nuts on the inboard (engine) side. Dearborn and San Jose built 1968 Mustangs had the nuts outboard. Just one of the many differences between the 3 assembly plants. I have no idea why Metuchen did it that way, but that is the way they did it.

Rodney
Rodney Harrold,Ohio SAAC Rep,SAAC 68 Shelby Concourse Judge,68 GT500KR 02267

Grouper Trooper

Jayson Horadam
1968 GT 350 #1516
2 X 4 Holley's sittin' on all SCAT 331
www.mpaenforcement.com